beautypg.com

4 upgrading the eclipse hx-pico application code, Upgrading the eclipse hx-pico application code, Connection – Clear-Com HX System Frames User Manual

Page 53

background image

6.4 Upgrading the Eclipse HX-PiCo application code

6.4.1 Upgrading the Eclipse HX-PiCo application code using EHX

with an Ethernet connection


Before you upgrade the Eclipse HX-PiCo card application code, check that:

• The PC can successfully connect to the matrix with an Ethernet connection by viewing the

Event Log (Diagnostics > Event Log) in EHX.

• There is a valid configuration in the matrix. A valid configuration enables the matrix to identify

its IP address and run its TCP / IP stack.

To upgrade Eclipse HX-PiCo application code using EHX with an Ethernet connection:

1. Ensure that you have the following equipment:

Required equipment

Description / comments

PC with an Ethernet connector

-

LAN cable for the PC-to-Eclipse
HX PiCo connection

For direct connections, use Ethernet crossover cable.
If the connection passes through an Ethernet switch
on its way to the PC / matrix, use straight CAT5 cable.

EHX installation

EHX must be configured and operational.

An EHX configuration file (*.ccn
or *.hxn file format)

The configuration file must have an appropriate IP
address set.

The appropriate *.fwr data file for
the Eclipse HX-PiCo

You can find the *.fwr data file on the software DVD
at:

Software DVD > Eclipse HX-PiCo > xxxxxxZ –
Application
(where xxxxxxZ represents the product
number).

Table 11: Required equipment

2. Start EHX. Select File > Matrix Connection.

3. In the Matrix Connection dialog, select the Ethernet communications option.

4. Connect the PC with the Eclipse HX-PiCo, using the LAN port on the rear of the matrix.

46

Eclipse HX Upgrade Guide

This manual is related to the following products: