Clear-Com HX System Frames User Manual
Page 135
6. The following Tera-Term boot up message is displayed.
Note:
Do not proceed until you see the boot up message. If you do not see the boot up message,
check your wiring connections and software settings. Repeat steps 1 - 6.
Figure 92: Boot up message
7. Press the 1 key on the PC keyboard. Press Enter to access the Checksums and Versions
information on the I-Series panel.
The boot code version and application code versions are displayed on the Tera-Term screen.
Note:
Do not proceed until the version information is displayed, as shown below.
Figure 93: Version and application code (firmware) versions
128
Eclipse HX Upgrade Guide
This manual is related to the following products: