14 upgrading the tel-14 module, 1 upgrading the tel-14 hardware, Upgrading the tel-14 module – Clear-Com HX System Frames User Manual
Page 148: Upgrading the tel-14 hardware
14 Upgrading the TEL-14 module
This chapter describes how to upgrade the TEL-14 module, including how to:
• Replace the TEL-14 processor.
• Re-fit TEL-14 modules.
• Update TEL-14 firmware.
Note:
This guide is laid out in the order in which you must upgrade your Eclipse HX software and hardware
devices. For a quick reference to upgrading your system, see
3 Quick reference: Upgrading to Eclipse HX.
14.1 Upgrading the TEL-14 hardware
To upgrade the TEL-14 hardware, you require the following equipment:
• The old Tel-14 card
• The replacement TEL-14 processor module.
• Flash Magic Software. Third party software is available from either of the Eclipse HX
7.5 DVDs:
Software DVD > 3rd_Party_Software > FlashMagic
Hardware DVD > 3rd_Party_Software > FlashMagic
Tip:
For more information about installing Flash Magic, see
• TEL-14 application software. The TEL-14 application software (*.HEX format file) is
available from the software DVD:
Software DVD > Other_Software >xxxxxxZ-TEL-14 Application
Where xxxxxxZ represents the product number.
To upgrade the TEL-14 hardware:
1. Remove the four screws securing the front panel and remove the front panel.
2. Remove the three screws securing the PCB without the backplane connector and open the
two cards up. It is not necessary to disconnect the two cards.
3. Remove the original processor (IC20) from its socket.
141
Eclipse HX Upgrade Guide