Clear-Com HX System Frames User Manual
Page 79
To upgrade MVX-A16 H8 application code using EHX:
1. Ensure that you have the following equipment:
Required equipment
Description / comments
PC with an Ethernet connector
-
Serial cable or Ethernet cable for
the PC to matrix connection.
-
EHX installation
EHX must be configured and operational.
An EHX configuration file (*.hxn)
The configuration file must have an appropriate IP
address set.
The appropriate *.fwc format file
for the MVX-A16 card
You can find the *.fwc file on the software DVD:
Software DVD > Eclipse HX-Omega-Median-Delta >
xxxxxxZ-MVX Application (where xxxxxxZ
represents the product number).
Table 21: Required equipment
2. Start EHX on the PC.
3. Connect the PC to the matrix using either Ethernet or a serial communications port.
4. Open the EHX configuration map within EHX. Select System > Layout.
5. Right click the matrix and then select Firmware> Update Firmware.
6. The Update Firmware wizard dialog is displayed. Click Next.
In the Select Hardware Type screen, ensure that the Card radio button is selected.
Figure 45: Select Hardware Type
7. In the next dialog, click Browse and navigate to the required *.fwc file for the MVX-A16 card
application:
a. Go to Software DVD > Eclipse HX-Omega-Median-Delta > xxxxxZ – MVX
Application (where xxxxxxZ represents the part number).
The folder contains the *.fwc file and a Read Me file (*.txt) with version information.
b. Select the*.fwc file and click OK / Open.
72
Eclipse HX Upgrade Guide