Clear-Com HX System Frames - Manual (Page 90)

b. Provide the second and fourth devices (the FPGA Flashes) with images. In the
Assign New Configuration File dialog, select the FPGA image for the second
device, the router FPGA Flash.
Go to Hardware DVD > Eclipse HX-Omega-Median-Delta > xxxxxxZ-Fibre Router
(front) FPGA (where xxxxxxZ represents the product number).
The folder contains the FPGA file (*.mcs format) and a Read Me file (*.txt), which
contains version information.
c. Select the FPGA image for the fourth device, the networking FPGA Flash.
Go to Hardware DVD > Eclipse HX-Omega-Median-Delta > xxxxxxZ-Fibre
Networking (rear) FPGA (where xxxxxxZ represents the product number).
The folder contains the FPGA file (*.mcs format) and a Read Me file (*.txt), which
contains version information.
9. A summary dialog is presented. For the FPGA Flash device(s), ensure that the Erase Before
Programming and Verify flags are set. Click OK.
Figure 51: Example Xilinx device programming properties
10. The upgrade (programming) starts, and takes approximately 2 minutes to complete. When the
upgrade is complete, the Program Succeeded message is displayed in the main window.
11. Power down the UUT.
83 Eclipse HX Upgrade Guide