Clear-Com HX System Frames User Manual
Page 111
11. Connect the MVX serial cable
(CAB-MVX-48Z) between the PC serial port and the E-QUE
card (MK2) serial connector (CON-2200):
Figure 73: E-QUE card (MK2) serial connector
12. Reinsert the E-QUE card (MK2) into the rack.
13. Power up the Eclipse HX-Median / Eclipse HX-Omega matrix / Eclipse HX-Delta matrix (if it is
not already powered up).
14. Ensure that the E-QUE card (MK2) and the PC are either:
• Connected to your Ethernet network.
• Directly connected using a crossover Ethernet cable.
The LAN connector on the E-QUE card is the highest RJ-45 socket on the back panel. When
the E-QUE (MK2) card is connected to the PC or to the network, check that the LAN LEDs
(the
yellow
and
green
lights at the bottom of the card) are flashing occasionally, indicating a
network connection.
104
Eclipse HX Upgrade Guide