Clear-Com HX System Frames - Manual (Page 102)

11. Connect the MVX serial cable
(CAB-MVX-48Z) between the PC serial port and the E-QUE
card (MK2) CON-2200.
Reinsert the E-QUE card (MK2) into the rack:
Figure 63: E-QUE card (MK2) serial connector
12. Power up the Eclipse HX-Median / Eclipse HX-Omega / Eclipse HX-Delta matrix (if not
already powered up).
13. Ensure that the E-QUE card (MK2) and the PC are either:
• Connected to your Ethernet network.
• Directly connected using a crossover Ethernet cable.
The LAN connector on the E-QUE card is the highest RJ-45 socket on the back panel. When
the E-QUE card is connected to the PC or to the network, check that the LAN LEDs (the
yellow and green lights at the bottom of the card) are flashing occasionally, indicating a
network connection.
95 Eclipse HX Upgrade Guide