Clear-Com HX System Frames - Manual (Page 64)

6.5 Upgrading the Eclipse HX-PiCo MVX code
The Eclipse HX-PiCo has two MVX cards (or sections) on the same PCB, both of which require
upgrading.
If you are upgrading from ECS v5.2.4, Clear-Com recommends upgrading the Eclipse HX-PiCo with
the combined MVX boot and application code file (*.mot), using the Renesas Flash Development Tool
(FDT).
If you are upgrading an existing Eclipse HX installation, you can upgrade:
• The MVX application code separately (*.fwc), using EHX.
• The MVX boot code separately (*.mot), using the Renesas FDT method.
• The MVX boot and application code simultaneously, using the Renesas FDT method and the
combined MVX boot and application code file (*.mot).
MVX code Renesas FDT method EHX method
MVX boot code (*.mot) -
MVX application code (.fwc) -
Combined MVX boot and
application code (*mot) -
Table 15: Upgrading the Eclipse HX-PiCo MVX code
Important note:
Because of small differences in PCB layout, it may not be possible to complete the upgrade of the
MVX application code on a small number of Eclipse HX-PiCo units, using EHX. If the upgrade fails,
you can still upgrade the MVX application code using Renesas FDT
(which is suitable for all Eclipse HX-PiCo units).
57 Eclipse HX Upgrade Guide