Siemens TC63 - Manual (Page 85)

TC63 AT Command Set
3.5 ATS18
s
TC63_ATC_V00.490 Page 85 of 501 5/24/05
Confidential / Draft - Do not copy
3.5 ATS18 Extended call release report
ATS18
controls the presentation of extended call release reports for circuit switched fax and data calls. Extended
call release reports related to voice calls are controlled via
AT+CEER
.
The call release report is presented in numeric format and shows as follows:
If enabled the message will be reported every time a fax or data call is released or fails to be established.
Syntax
Parameter Description
An odd number enables the presentation of the extended call release report. Any even number disables this
feature.
0
(&F) ...255
Location ID as number code, see also of
AT+CEER
.
Location IDs are listed in Section 3.4.1 , Cause Location ID for the extended error report . Each ID is related to
another table that contains a list of s.
Reason for last call release as number code (see also of
AT+CEER
).
numbers and the associated descriptions are listed in several tables, sorted by different categories
at
AT+CEER
. The tables can be found proceeding from the Location IDs listed in Section 3.4.1 , Cause Location
ID for the extended error report .
+CAUSE: :
Read Command
ATS18?
Response(s)
OK
Write Command
ATS18=
Response(s)
OK
ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 ! % ! % % ! ! ! % !
(num)(&W)(&V)
(num)
(num)