Siemens TC63 - Manual (Page 199)

TC63 AT Command Set
8.10 AT^SMONG
s
TC63_ATC_V00.490 Page 199 of 501 5/24/05
Confidential / Draft - Do not copy
Note
• For compatibility with earlier products and to support legacy applications, often any input character will stop
the periodic output of the write command. But since this applies only in certain cases (depending on the set-
tings of
AT+IPR
and
AT+CMUX
), it is recommended to always use "at" or "AT".
8.10.1 AT^SMONG Cell Info Table
Example output for
AT^SMONG
:
Columns of the cell info table:
GPRS Monitor
BCCH G PBCCH PAT MCC MNC NOM TA RAC # Cell #
0637 1 - 4 234 05 2 00 0B
Column Description
BCCH ARFCN of BCCH carrier
G GPRS status:
0 GPRS not available in currently used cell
1 GPRS available in currently used cell
2 GPRS attached
Note: During a voice call or CSD connection, GPRS services are not available, and con-
sequently G=0 is displayed.
PBCCH If PBCCH is present, indication of ARFCN, else ''-'' or if Frequency Hopping is used ''H''
PAT Priority Access Threshold (GSM Rec. 04.08 / 10.5.2.37b)
0 Packet access is not allowed in the cell
1 Spare, shall be interpreted as "000" (packet access not allowed)
2 Spare, shall be interpreted as "000" (packet access not allowed)
3 Packet access is allowed for priority level 1
4 Packet access is allowed for priority level 1 to 2
MCC Mobile Country Code
MNC Mobile Network Code
NOM Network Operation Mode (1...3)
TA Timing Advance Value
RAC Routing Area Code (as hexadecimal value)