Siemens TC63 - Manual (Page 229)

TC63 AT Command Set
9.12 AT+CPUC
s
TC63_ATC_V00.490 Page 229 of 501 5/24/05
Confidential / Draft - Do not copy
9.12 AT+CPUC Price per unit and currency table
Syntax
Command Description
Read command returns the current parameters of PUC.
Write command sets the parameters of Advice of Charge related price per unit and currency table. SIM PIN2 is
usually required to set the parameters.
Parameter Description
Three-character currency code (e.g. "GBP", "EUR"). If the currency name is longer than three characters, all
characters will be cut off after the third position. Before they are written to the SIM Card, these characters are
converted to the standard GSM alphabet.
Price per unit; dot is used as a decimal separator (e.g. "2.66"). The length is limited to 20 characters. If the string
length is exceeded, the command is terminated with an error. This string may only contain digits and a dot. Lead-
ing zeros are removed from the string. The minimum and maximum value are determined by the structure of the
SIM-PUCT file. The maximum price per unit value is 999 999 999.00. When successfully entered, this value is
rounded to maximum accuracy.
Note: Due to storage in mantisse (range 0-4095) and exponent (-7 to 7) it is possible that rounding errors occur.
SIM PIN2. String parameter which can contain any combination of characters. The maximum string length is
limited to 8 characters. If this value is exceeded, the command terminates with an error message. If the PIN2 is
incorrect, a CME error (+CME ERROR: incorrect password) is output.
Test Command
AT+CPUC=?
Response(s)
OK
Read Command
AT+CPUC?
Response(s)
+CPUC:
,
OK
ERROR
+CME ERROR:
Write Command
AT+CPUC=
, [, ]
Response(s)
OK
ERROR
+CME ERROR:
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 % % % % % % % ! % !
(str)(+CSCS)
(str)
(str)