Siemens TC63 - Manual (Page 118)

TC63 AT Command Set
5.4 AT+CLCK
s
TC63_ATC_V00.490 Page 118 of 501 5/24/05
Confidential / Draft - Do not copy
5.4 AT+CLCK Facility lock
AT+CLCK
can be used to lock, unlock or interrogate a network or ME . The command can be
aborted when network facilities are being set or interrogated.
Syntax
Parameter Description
Phone security locks set by client or factory
Primarily intended for the client to take safety precautions, "SC", "PS" and "FD" can be configured individually.
"PS" may also be factory set.
Parameter is not applicable to security locks.
See examples below for further details.
“SC“
SIM (lock SIM cards). SIM requests password upon ME power-up and when
this lock command is issued.
: SIM PIN1.
“PS“ Phone locked to SIM card. ME requests password when other than current SIM
card is inserted.
"PS" lock is frequently referred to as "phone lock", or "device lock". Accord-
ingly, the password may be called "phone code" or "device code". The "PS"
password is not associated with the PUK of the SIM card. If incorrectly entered
three times, the Master Phone Code is required to lift the lock. This is an 8-digit
device code associated to the IMEI number of the mobile which can only by
obtained from the manufacturer of the module. Once the Master Phone Code
has been acctepted, the mobile is operational, and the "PS" lock is no longer
active. If needed it must be set once again.
Test Command
AT+CLCK=?
Response(s)
+CLCK:
list of supported s
OK
Write Command
AT+CLCK=
, [, ][, ]
Response(s)
if is not equal 2 and command successful:
OK
if
= 2 and command successful:
+CLCK:
[, ]
[+CLCK: [, ]]
[+CLCK: ...]
OK
If error is related to ME functionality
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07, GSM 02.04, GSM 02.88,
GSM 03.88, GSM 04.88
% % % % % % % ! § !
(str)