Indvalue, Mode, Adnentry – Siemens TC63 User Manual
Page 75: 2 display, The following two sim elementary, Tc63 at command set
TC63 AT Command Set
3.3 AT^SIND
s
TC63_ATC_V00.490
Page 75 of 501
5/24/05
Confidential / Draft - Do not copy
manual network selection fails and the module automatically falls back to the
previous network the NITZ values cannot be recalled. Nevertheless an indi-
cated time zone is valid until a new MMI/GMMI will trigger another NITZ indi-
cation.
“band“
Currently selected frequency band or band combination.
Integer type value in the range stated above for the corresponding
.
Notes specific to the EONS feature:
If the indicator is "eons", the
is a type associated to the operator name according to GSM 22.101
. This type depends on the source of the operator name.
Priority of types associated to the operator names is defined as follows (the type listed first has the highest pri-
ority). If a type cannot be indicated the next one will be used.
The name information received by the NITZ service (type 3) will be saved in the non-volatile RAM. It replaces
the operator name of the registered PLMN (type 4) or its numeric form (type 5) stored in the ME. However, when
after restart the ME registers to another PLMN that is not equal to the saved NITZ name information, the NITZ
name information must be invalidated.
If the type is 2, 4 or 5,
displays the same operator name.
0
Indicator is deregistered, i.e. no such indicator event report (URC) will be
issued.
=0 is power-up and factory default of indicators defined by
only.
1
Indicator is registered.
• Indicator event reports are controlled via
• All indicators can be registered or deregistered via
default settings apply: Power-up and factory default of the indicators sup-
is
=1, while, as stated above, indicators defined
only are set to
=0.
2
Query the registration status and the current value of a single indicator type.
ADN phonebook record number on the SIM.
1...14 Identical with
of
. The value indicates the band(s) cur-
rently available for network selection, depending on the network config-
uration either a single band or a dualband combination. The URC
appears whenever the status of the currently available band(s)
changes, for example after using the
command to change
the "Radio/Band" parameters
. Please see
for further detail about the feature "Radio/Band" selection.
(num)
0
Not registered.
1
EF-OPL and EF-PNN (alphanumeric format, can contain up to 24 characters.)
2
Operator Name String in long and short format according to Common PCN
Handset Specification (CPHS)
(alphanumeric format, can contain up to 16
characters).
3
Name information received by the NITZ service long and short form (alphanu-
meric format, can contain up to 16 characters). The short form will be displayed
only if EF
OPShort
from CPHS is available.
4
Any operator name stored internal to the ME (alphanumeric format, can con-
tain up to 16 characters).
5
Broadcast MCC-MNC (numeric format which consists of a 3-digit country code
plus a 2- or 3-digit network code).
(num)
(num)