19 atd*98# request gprs ip service, Atd*98, The mt iss – Siemens TC63 User Manual
Page 305: Ility commands, Tc63 at command set
TC63 AT Command Set
11.19 ATD*98#
s
TC63_ATC_V00.490
Page 305 of 501
5/24/05
Confidential / Draft - Do not copy
11.19
ATD*98# Request GPRS IP service
This command causes the MT to perform whatever actions are necessary to establish a communication between
the TE and the external PDN.
The V.250 'D' (Dial) command causes the MT to enter the V.250 online data state and, with the TE, to start the
layer 2 protocol.
GPRS attachment and PDP context activation procedures may take place prior to or during the PDP startup if
they have not already been performed using the
and
commands.
To confirm acceptance of the command before entering the V.250 online data state command will respond with
CONNECT.
When the layer 2 protocol has terminated, either as a result of an orderly shut down of the PDP or an error, the
MT enters V.250 command state and returns NO CARRIER (for details refer to Section
tivation of PDP context during dial-up PPP
Syntax
Parameter Description
Parameter specifies a particular PDP context definition (see
command). If no context is specified,
an internal context with default properties is used (see
and
).
1...2
Notes
• If TC63 is in dedicated mode, command returns the result code BUSY.
•
is used as a standard V.250 AT command, too.
Exec Command
ATD*98
[*
Response(s)
CONNECT
NO CARRIER
Reference(s)
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07
%
%
§
%
%
§
§
!
!
%
(num)