Cpin, Code, Tc63 at command set – Siemens TC63 User Manual
Page 109
TC63 AT Command Set
5.1 AT+CPIN
s
TC63_ATC_V00.490
Page 109 of 501
5/24/05
Confidential / Draft - Do not copy
SIM PIN authentication
READY
PIN has already been entered. No further entry needed.
SIM PIN
ME is waiting for SIM PIN1.
SIM PUK
ME is waiting for SIM PUK1 if PIN1 was disabled after three failed attempts to
enter PIN1.
SIM PIN2
ME is waiting for PIN2. This is only applicable when an attempt to access a
PIN2 related feature was acknowledged with +CME ERROR: 17 ("SIM PIN2
required"), for example when the client attempts to edit the FD phonebook). In
this case the read command
? also prompts for SIM PIN2. Normally,
the
command is intended for SIM PIN2.
SIM PUK2
ME is waiting for PUK2 to unblock a disabled PIN2. As above, this is only nec-
essary when the preceding command was acknowledged with +CME ERROR:
18 ("SIM PUK2 required") and only if the read command
? also
prompts for SIM PUK2. Normally, the
command is intended for SIM
PUK2.
Phone security locks set by client or factory
PH-SIM PIN
ME is waiting for phone-to-SIM card password if "PS" lock is active and the cli-
ent inserts other SIM card than the one used for the lock. ("PS" lock is also
referred to as phone or antitheft lock).
PH-SIM PUK
ME is waiting for Master Phone Code, if the above "PS" lock password was
incorrectly entered three times.
PH-FSIM PIN
ME is waiting for phone-to-very-first-SIM card. Necessary when "PF" lock was
set. When powered up the first time, ME locks itself to the first SIM card put into
the card holder. As a result, operation of the mobile is restricted to this one SIM
card (unless the PH-FSIM PUK is used as described below).
PH-FSIM PUK
ME is waiting for phone-to-very-first-SIM card unblocking password to be
given. Necessary when "PF" lock is active and other than first SIM card is
inserted.
PH-NET PUK
ME is waiting for network personalisation unblocking password
PH-NS PIN
ME is waiting for network subset personalisation password
PH-NS PUK
ME is waiting for network subset unblocking password
PH-SP PIN
ME is waiting for service provider personalisation password
PH-SP PUK
ME is waiting for service provider personalisation unblocking password
PH-C PIN
ME is waiting for corporate personalisation password
PH-C PUK
ME is waiting for corprorate personalisation un-blocking password
Notes
• Caution: After entering a password with
all other commands that need access to data on the SIM
card may be blocked for up to 20 seconds!
• Successful PIN authentication only confirms that the entered PIN was recognized and correct. The output of
the result code OK does not necessarily imply that the mobile is registered to the desired network.
Typical example: PIN was entered and accepted with OK, but the ME fails to register to the network. This may
be due to missing network coverage, denied network access with currently used SIM card, no valid roaming
agreement between home network and currently available operators etc.
TC63 offers various options to verify the present status of network registration: For example, the
command indicates the currently used network. With
you can also check the current status and acti-
vate an unsolicited result code which appears whenever the status of the network registration changes (e.g.
when the ME is powered up, or when the network cell changes).
• Wait 10 seconds after PIN input before using SMS related commands.
(text)