Siemens TC63 - Manual (Page 281)

TC63 AT Command Set
11.7 AT+CGEQMIN
s
TC63_ATC_V00.490 Page 281 of 501 5/24/05
Confidential / Draft - Do not copy
This parameter indicates whether the UMTS bearer shall provide in-sequence SDU delivery or not.
0
no
1 yes
[2] subscribed value
This parameter indicates the maximum allowed SDU size in octets.
[0]
subscribed value
10...1520 (value needs to be divisible by 10 without remainder)
1502
This parameter indicates the target value for the fraction of SDUs lost or detected as erroneous. SDU error ratio
is defined only for conforming traffic. The value is specified as "mEe". As an example a target SDU error ratio
of 5*10 -3 would be specified as "5E3" (e.g.
AT+CGEQMIN
=...,"5E3",...).
[“0E0“] subscribed value
“1E2“
“7E3“
“1E3“
“1E4“
“1E5“
“1E6“
“1E1“
This parameter indicates the target value for the undetected bit error ratio in the delivered SDUs. If no error
detection is requested, Residual bit error ratio indicates the bit error ratio in the delivered SDUs. The value is
specified as "mEe". As an example a target residual bit error ratio of 5*10 -3 would be specified as "5E3" (e.g.
AT+CGEQMIN
=...,"5E3",...).
[“0E0“] subscribed value
“5E2“
“1E2“
“5E3“
“4E3“
“1E3“
“1E4“
“1E5“
“1E6“
“6E8“
This parameter indicates whether SDUs detected as erroneous shall be delivered or not.
0
no
(num)
(num)
(str)
(str)
(num)