Siemens TC63 - Manual (Page 417)

TC63 AT Command Set
18.8 AT^SAIC
s
TC63_ATC_V00.490 Page 417 of 501 5/24/05
Confidential / Draft - Do not copy
18.8 AT^SAIC Audio Interface Configuration
AT^SAIC
configures the interface connections of the active audio mode. The write command is usable in audio
modes 2 to 6 only.
If
AT^SNFS
=1, any attempt to use
AT^SAIC
write command is rejected with error response. This is because all
default parameters in audio mode 1 are determined for type approval and are not adjustable.
To allocate a specific audio mode to one of the audio interfaces, first select the audio mode with
AT^SNFS
and
then choose the interface using
AT^SAIC
.
Syntax
Parameter Description
Input and output selection
1
Digital input and output
2 Analog input and output
Microphone selection
1
Microphone 1
2 Microphone 2
Select differential earpiece amplifier
1
Selects the earpiece amplifier 1
2 Selects the earpiece amplifier 2
3 Selects both amplifiers. Note that both amplifiers are connected in parallel and
therefore, get the same output power if =3.
Test Command
AT^SAIC=?
Response(s)
^SAIC:
(list of supported s), (list of supported s), (list of supported s)
OK
Read Command
AT^SAIC?
Response(s)
^SAIC:
, ,
OK
Write Command
AT^SAIC=
[, [, ]]
Response(s)
OK
ERROR
+CME ERROR: operation not allowed
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS ! % % % % % % ! % !
(num)(^SNFW)
(num)(^SNFW)
(num)(^SNFW)