Siemens TC63 User Manual
Page 236
TC63 AT Command Set
s
TC63_ATC_V00.490
Page 236 of 501
5/24/05
Confidential / Draft - Do not copy
and can be active at the same time. This allows the user to have two parallel GPRS connections: for example
for sending or receiving emails over a GPRS connection enabled by the TCP/IP stack while, at the same time,
surfing the Internet over a Dial-Up Network GPRS connection.
Using Internet Service AT commands on several interfaces (ASC0, ASC1, USB or Multiplex mode on ASC0):
• A connection profile can be created on one interface and then viewed or changed on all other interfaces.
• A service profile can be used only on one interface at a time:
- Changes to a service profile are allowed only on the same interface where it was created, trying to change
it on another interface is denied with "+CME ERROR: Invalid index". If queried with the read command
the entire profile is returned on the interface where the service profile was created, while on all
other interfaces only the service type of the profile is stated.
- If a service profile is active (after opening it with
) on one interface, any attempt to open or close
the same service profile on another interface is denied with "+CME ERROR: Operation temporary not
allowed".
- To free a service profile for use on another interface, use the
command and select service type
= "none". This action deletes the entire profile and restores all parameters of the profile to their initial
power-up state (all values are empty). For example, to remove the service profile 3, set
=3,svr-
type,none. After this, a new profile 3 can be created on any other interface.
Address notation
Server addresses must be provided as IP addresses in standard dot-format (e.g. "192.168.1.2") or as server
address names resolvable by a DNS server (e.g. "smtp.myserver.de" or "pop3.myserver.de").
Inactivity timeouts
Inactivity timeouts are not part of the Internet AT command functionality implemented in TC63 and, if desired,
are the responsibility of the host application. It is recommended that the host application validates URCs and AT
command responses and reacts adequately, for example by sending a close message or starting a timer.