Siemens TC63 - Manual (Page 361)

TC63 AT Command Set
13.27 AT^SSDA
s
TC63_ATC_V00.490 Page 361 of 501 5/24/05
Confidential / Draft - Do not copy
13.27 AT^SSDA Set SMS Display Availability
This command allows to notify the TC63 of its controlling application's capability to immediately display incoming
SMS on a display.
If the application is able to display incoming SMS, class 0 SMS shall be displayed immediately. However, if it
does not, class 0 SMS shall be treated as if no message class is determined (GSM 03.38 [19] ).
The effect of this command if =1 is to determine the behavior of parameter of
AT+CNMI
:
If =1 and =1 incoming class 0 SMS need to be acknowledged with
AT+CNMA
(see also
AT+CNMI
and
AT+CSMS
)
If multiplex mode is enabled (
AT+CMUX
) and =1 with =1 is set on any logical channel, all other chan-
nels have to use =0.
Syntax
Command Description
The read command returns ME's current capability setting.
Parameter Description
Display Availability
0
(&F) Application is not able to display incoming SMS
1 Application is able to display incoming SMS
Note
• If the ME operates on different instances (MUX channels 1, 2, 3 or ASC0/ASC1) avoid different settings for
routing and indicating SMS. For example, if messages shall be routed directly to one instance of the TE (set
with
AT+CNMI
,
AT^SSDA
), it is not possible to activate the presentation of URCs with
AT+CMER
or
AT+CNMI
on another instance. Any attempt to activate settings that conflict with existing settings on another interface,
will result in CME ERROR, or accordingly CMS ERROR.
Test Command
AT^SSDA=?
Response(s)
^SSDA:
list of supported s
OK
Read Command
AT^SSDA?
Response(s)
^SSDA:
OK
Write Command
AT^SSDA=
Response(s)
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS ! % % % % % % ! % !
(num)