Siemens TC63 - Manual (Page 215)

TC63 AT Command Set
9.6 AT+CCFC
s
TC63_ATC_V00.490 Page 215 of 501 5/24/05
Confidential / Draft - Do not copy
String type phone number of forwarding address in format specified by . If you select = 3, the
phone will be registered in the network. This allows you to disable / enable CF to the same destination
without the need to enter the phone number once again. Depending on the services offered by the provider the
registration may be mandatory before CF can be used. The number remains registered in the network until you
register another number or erase it using = 4.
Type of address octect
145
dialing string includes international access code character '+'
129 otherwise
Integer or sum of integers each representing a class of information, i.e. a bearer service, telecommunication ser-
vice or bearer service group as defined in "GSM 02.04"
1
voice
2 data
2 (data) comprises all those values between 16 and 128, that
are supported both by the network and the MS. This means, a setting made for
2 applies to all remaining data classes (if supported). In addition, you
can assign a different setting to a specific class. For example, you can activate
Call Forwarding for all data classes, but deactivate it for a specific data class.
4 fax
8 SMS
16 data circuit sync
32 data circuit async
64 dedicated packet access
128 dedicated PAD access
1...[7]...255 combination of some of the above classes. For example, the default setting 7
represents the sum of the integers 1, 2 and 4 (CF for voice, data and fax). The
value 255 covers all classes. If the parameter is omitted, the default
value 7 is used.
5...[20]...30 Time to wait before call is forwarded, rounded to a multiple of 5 sec. (only for
=no reply)
0 Call Forwarding not active
1 Call Forwarding active
Notes
• You can register, disable, enable and erase 4 and 5 as described above. However, querying the
status of 4 and 5 with AT+CCFC will result in an error ("CME error: Operation not supported"). As
an alternative, you may use the ATD command followed by *'# codes to check the status of these two reasons.
See
Star-Hash (*#) Network Commands
for a complete list of *# GSM codes. See also examples below.
• Most networks will not permit registration of new parameters for conditional call forwarding (reasons 1,2,3,5)
while unconditional call forwarding is enabled.
• The
AT+CCFC
command offers a broad range of call forwarding options according to the GSM specifications.
(str)
(num)
(num)
(num)
(num)