Tc63 at command set – Siemens TC63 User Manual

Page 146

TC63 AT Command Set

7.5 ATD>

TC63_ATC_V00.490

Page 146 of 501

5/24/05

Confidential / Draft - Do not copy

7.5

ATD> Mobile originated call from active memory using index
number

Syntax

Command Description

TA attempts to set up an outgoing call to the stored number. The termination character ";" is mandatory since

dialing from a phonebook is only supported for voice calls and for sending *# codes of Supplementary Services

or other functions.

Parameter Description

Integer type memory location in the range of locations available in the selected memory, i.e. the index number

returned by

AT+CPBR

String of GSM modifiers:

I Activates CLIR (disables presentation of own phone number to called party)

i Deactivates CLIR (enables presentation of own phone number to called party)

Notes

• This command may be aborted generally by receiving a character during execution. Abortion is not possible

during some states of connection setup such as handshaking.

• The command is not applicable to data calls. Any attempt to dial a data call number from

causes the

result code "NO CARRIER" to appear.

• Parameter

only if no *# code is within the dialing string.

Exec Command

ATD>

[

];

Response(s)

ERROR

+CME ERROR:
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
When TA returns to command mode after call release:
OK
If successfully connected:
OK

Reference(s)

ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge

Last

V.250

(num)

(str)