Siemens TC63 - Manual (Page 68)

TC63 AT Command Set
3.2 AT+CIND
s
TC63_ATC_V00.490 Page 68 of 501 5/24/05
Confidential / Draft - Do not copy
3.2 AT+CIND Indicator control
The
AT+CIND
command controls the presentation of Indicator Event Reports related to various functions such
as battery charge level, signal quality, service availability, sound generation, indication of unread short mes-
sages, full SMS storage, call in progress or roaming activities.
Use of
AT+CIND
has become outdated. Rather we recommend the more powerful
AT^SIND
command which is
easier to use and provides additional indicators. All indicators provided by
AT+CIND
can be handled with
AT^SIND
as well.
AT+CIND
supports two ways to get the values related to indicators:
• One approach is to query the current status of each indicator by using the read command
AT+CIND
?. It
returns the status no matter whether the indicator has been registered with the write command
AT+CIND
=[ [, [,...]]].
• The other way is an event-driven notification based on the "
+CIEV
" URCs. In this case, the ME will automat-
ically send a message to the application, whenever the value of an indicator changes. The application should
be designed to react adequately when receiving a URC.
The presentation of these URCs depends on two settings:
- The indicators must be registered with the write command
AT+CIND
=[ [, [,...]]]. When the
ME is switched on all of them are in registered mode. Any indicator can be excluded if deregistered with
=0. To register or deregister an indicator the
AT+CIND
write command requires to type the value
=1 or 0 exactly at the position where the indicator is located in the list. This is not necessary with
AT^SIND
which allows to specify indicators by name. See examples below.
- The presentation of the registered indicators must be enabled with
AT+CMER
.
Syntax
Parameter Description
Integer type value, which shall be in range of corresponding
Test Command
AT+CIND=?
Response(s)
+CIND:
( , list of supported s)[, ( , list of supported s)[,
...]]
OK
Read Command
AT+CIND?
Response(s)
+CIND:
[, [, ...]]
OK
ERROR
+CME ERROR:
Write Command
AT+CIND=
[, [, ...]]
Response(s)
OK
ERROR
+CME ERROR:
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 ! % % % % % % ! % !
(num)