2 ats3 set command line termination character, Ats3, Defau – Siemens TC63 User Manual

Page 458: Tc63 at command set

Text mode
Original mode

TC63 AT Command Set

20.2 ATS3

TC63_ATC_V00.490

Page 458 of 501

5/24/05

Confidential / Draft - Do not copy

20.2

ATS3 Set command line termination character

The

ATS3

command determines the character recognized by the TA to terminate an incoming command line.

Syntax

Parameter Description

command line termination character
000...13

(&F)

...127

Notes

• Using a value other than the default 13 may cause problems when entering commands.
• Whenever you change the setting take into account that the new value has no effect on the URC "

^SHUT-

DOWN

Read Command

ATS3?

Response(s)

Write Command

ATS3=

Response(s)

ERROR

Reference(s)

ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge

Last

V.250

(num)(&W)(&V)