Siemens TC63 - Manual (Page 174)

TC63 AT Command Set
7.25 AT+CSNS
s
TC63_ATC_V00.490 Page 174 of 501 5/24/05
Confidential / Draft - Do not copy
7.25 AT+CSNS Single Numbering Scheme
Syntax
Command Description
The
AT+CSNS
command enables the ME to accept incoming calls when no bearer capability information is pro-
vided with the call, e.g. single numbering scheme calls or calls originitating from analog devices.
Parameter Description
[0] (D) Voice: Each call received without bearer element is assumed to be speech
2 Fax: Each call received withoutbearer element is assumed to be an incoming
fax.
4 Data: Each call received without bearer element is assumed to be a data call.
Please take into account that the bearer service parameters set with
AT+CBST
apply to all data calls including those received without bearer capability.
Notes
• The command must be set before the call comes. By default, when you do not modify the settings, all calls
received without bearer element are assumed to be voice.
• The setting will be automatically saved when you power down the GSM engine with
AT^SMSO
, provided that
PIN authentication has been done. This value will be restored when PIN authentication is done again.
Test Command
AT+CSNS=?
Response(s)
+CSNS:
(list of supported s)
OK
Read Command
AT+CSNS?
Response(s)
+CSNS:
OK
Write Command
AT+CSNS=
[ ]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 ! % % % % % % ! % !
(num)