Siemens TC63 - Manual (Page 272)

TC63 AT Command Set
11.3 AT+CGATT
s
TC63_ATC_V00.490 Page 272 of 501 5/24/05
Confidential / Draft - Do not copy
11.3 AT+CGATT GPRS attach or detach
Syntax
Command Description
The test command is used for requesting information on the supported GPRS service states.
The read command returns the current GPRS service state.
The write command is used to attach the MT to, or detach the MT from the GPRS service. After the command
has completed, the MT remains in V.250 command state. If the MT is already in the requested state, the com-
mand is ignored and the OK response is returned. Any active PDP contexts will be automatically deactivated
when the attachment state changes to detached.
Parameter Description
Indicates the state of GPRS attachement.
0
(P) detached
[1] attached
Notes
• If the MT is in dedicated mode, write command returns "+CME ERROR: operation temporary not allowed".
• When the module is GPRS attached and a PLMN reselection occurs to a non-GPRS network or to a network
where the SIM is not subscribed to for using GPRS, the resulting GMM (GPRS mobility management) state
according to GSM 24.008 is REGISTERED/NO CELL, meaning that the read command will still show
=1.
Test Command
AT+CGATT=?
Response(s)
+CGATT:
(list of supported s)
OK
Read Command
AT+CGATT?
Response(s)
+CGATT:
OK
Write Command
AT+CGATT=
[ ]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 % % % % % % % ! ! !
(num)