Siemens TC63 - Manual (Page 42)

TC63 AT Command Set
2.9 AT+CFUN
s
TC63_ATC_V00.490 Page 42 of 501 5/24/05
Confidential / Draft - Do not copy
The parameter can only be used if the serial interface is enabled.
Due to the command syntax, you need to enter parameter , followed by , where is only a
placeholder and has no effect. See examples below.
[0]
Placeholder for as stated above.
1 ME resets and restarts to full functionality. After reset and restart, PIN 1
authentication is necessary (
AT+CPIN
). If autobauding is enabled, it is recom-
mended to wait 3 to 5 seconds before entering the first AT command. For
details on autobauding refer to Section 4.9.1 , Autobauding .
Notes
• If both serial interfaces ASC0 and ASC1 are connected, any functionality level set with
AT+CFUN
takes effect
on both of them. In Multiplex mode, the CFUN profile is shared by all multiplexer channels.
• If the ME is in Multiplexer mode, it is not recommended to activate SLEEP mode with
AT+CFUN
= . The
best approach to properly control SLEEP mode in this case is to issue the PSC messages described in [5] ,
Section "Power saving control".
• When a circuit-switched call is in progress, =7 or 9 can be activated without terminating the call. How-
ever, setting =0 during a circuit-switched call immediately disconnects this call.
• To check whether power saving is on, you can query the status with the read command AT+CFUN? only if
the module is in full functionality mode or in CYCLIC SLEEP mode. If available, you can also take advantage
of the status LED controlled by the SYNC pin (see
AT^SSYNC
and [2] ). With
AT^SSYNC
you can select differ-
ent modes of LED signalization during SLEEP modes (see Section 19.6.1 , ME status indicated by status LED
patterns for details). However, the module can wake up temporarily from power saving without leaving its
CYCLIC SLEEP mode (without changing +CFUN " "), e.g. for a network scan after a loss of radio cov-
erage, or after receipt of serial data during CYCLIC SLEEP mode. During this "temporary wakeup state" the
LED will operate as if the ME was in full functionality mode.
• Recommendation: In NON-CYCLIC SLEEP mode, you can set an RTC alarm to wake up the ME and return
to full functionality. This is a useful approach because, in this mode, the AT interface is not accessible.
2.9.1 Wake up the ME from SLEEP mode
A wake-up event is any event that causes the ME to draw more current. Depending on the selected mode, the
wake-up event either switches the SLEEP mode off and takes the ME back to full functionality
AT+CFUN
=1, or
activates the ME temporarily without terminating the selected SLEEP mode.
Definitions of the state transitions described in Table 2.3 :
• Quit: ME exits SLEEP mode.
• Temporary: ME becomes active temporarily for the duration of the event and the mode-specific follow-up time
after the last character was sent or received on the serial interface.
• No effect: Event is not relevant in the selected SLEEP mode. The ME does not wake up.
Table 2.3: Wake-up events in NON-CYCLIC and CYCLIC SLEEP modes
(num)
Event Selected mode:
=0
Selected mode:
=7 or 9
Ignition line No effect No effect
/RTS0 or /RTS1 activation Quit Mode 7: No effect (RTS is only
used for flow control)
Mode 9: Temporary
Unsolicited Result Code (URC) Quit Temporary
Incoming voice or data call Quit Temporary