Aces (see also chapter, Commands, respec, Tc63 at command set – Siemens TC63 User Manual

Page 306

TC63 AT Command Set

11.20 ATH

TC63_ATC_V00.490

Page 306 of 501

5/24/05

Confidential / Draft - Do not copy

11.20

ATH Manual rejection of a network request for PDP context acti-
vation

The V.250

command may be used to deactivate all PDP contexts which are active or online on the same

interface. This command should not be used to deactivate PDP contexts during the implicit PDP context deacti-

vation procedure which is started automatically after LCP termination or by dropping the DTR line (if

configured). For details refer to Section

The

command may also be used to reject a network request for PDP context activation announced by the

unsolicited result codes "

: GPRS".

Syntax

Notes

• In contrast to GSM 07.07 it is possible to cancel a connection with

after a break. This is done for com-

patibility reasons due to the "dial-up network" drivers of Microsoft Windows.

•

is used as a standard V.250 AT command, too.

• If

is used to reject a network request for PDP context activation, then other PDP contexts on the same

interface which are active or online will not be deactivated.

Exec Command

ATH

Response(s)

Reference(s)

ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge

Last

GSM 07.07