18 atd*99# request gprs service, Atd*99, Gprs – Siemens TC63 User Manual
Page 304: Tc63 at command set
TC63 AT Command Set
11.18 ATD*99#
s
TC63_ATC_V00.490
Page 304 of 501
5/24/05
Confidential / Draft - Do not copy
11.18
ATD*99# Request GPRS service
This command causes the MT to perform whatever actions are necessary to establish a communication between
the TE and the external PDN.
The V.250 'D' (Dial) command causes the MT to enter the V.250 online data state and, with the TE, to start the
specified layer 2 protocol. No further commands may follow on the AT command line. GPRS attachment and
PDP context activation procedures may take place prior to or during the PDP startup if they have not already
been performed using the
and
commands.
Examples on how to use this command are provided in "Section
Using GPRS AT commands (Examples)
To confirm acceptance of the command before entering the V.250 online data state command will respond with
CONNECT.
When the layer 2 protocol has terminated, either as a result of an orderly shut down of the PDP or an error, the
MT enters V.250 command state and returns NO CARRIER (for details refer to Section
tivation of PDP context during dial-up PPP
Syntax
Parameter Description
This parameter is currently not used and needs not to be specified.
Layer 2 protocol to be used between the TE and MT.
“PPP“
layer 2 protocol PPP
“1“
layer 2 protocol PPP
Parameter specifies a particular PDP context definition (see
command). If no context is specified,
an internal context with default properties is used (see
and
).
1...2
Notes
• If TC63 is in dedicated mode, command returns the result code BUSY.
•
is used as a standard V.250 AT command, too.
Exec Command
ATD*99
][* [
]]]]#
Response(s)
CONNECT
NO CARRIER
Reference(s)
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07
%
%
§
%
%
§
§
!
!
%
(str)
(str)
(num)