1 at^srsa remote sim access activation, At^srsa, Tc63 at command set – Siemens TC63 User Manual
Page 376
TC63 AT Command Set
15.1 AT^SRSA
s
TC63_ATC_V00.490
Page 376 of 501
5/24/05
Confidential / Draft - Do not copy
15.1
AT^SRSA Remote SIM Access Activation
Syntax
Unsolicited Result Code
^SRSA:
This URC is generated if either the SIM usage scheme or the SAP connection status has changed due to SAP
message communication or AT command control.
Command Description
The read command can be used to request the current RSA settings. Every line outputs an RSA connection, if
any.
The write command allows to control the TC63's SIM usage scheme along with the related configuration param-
eters.
Parameter Description
Activation result
0
No Error
Parameters valid, SAP mode change initiated. However, actual mode change
is signaled via URC "
Other values indicate invalid activation requests, no SAP mode change is initi-
ated in the following cases:
1
Error unspecified.
2
Error activation command is busy.
3
Error activation started with serial multiplex mode is off.
4
Error activation started on invalid serial multiplex channel.
5
Error device Id is already known.
Test Command
AT^SRSA=?
Response(s)
^SRSA:
(list of supported
s) , (list
of supported
s) , (list of supported
s) , (list of supported
OK
Read Command
AT^SRSA?
Response(s)
,
OK
Write Command
AT^SRSA=
[,
[,
Response(s)
^SRSA:
OK
Reference(s)
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
SIEMENS
!
%
%
%
%
%
%
!
%
!
(num)