Siemens TC63 - Manual (Page 158)

TC63 AT Command Set
7.16 ATS10
s
TC63_ATC_V00.490 Page 158 of 501 5/24/05
Confidential / Draft - Do not copy
7.16 ATS10 Set disconnect delay after indicating the absence of data
carrier
Syntax
Command Description
This parameter setting determines the amount of time, that the TA remains connected in absence of a data car-
rier. If the data carrier is detected before disconnect, the TA remains connected.
Parameter Description
number of tenths of seconds of delay
001...2
(&F) ...254
Read Command
ATS10?
Response(s)
OK
Write Command
ATS10=
Response(s)
OK
ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 ! % ! % % ! ! ! % !
(num)(&W)(&V)