Siemens TC63 - Manual (Page 67)

TC63 AT Command Set
3.1 AT+CMER
s
TC63_ATC_V00.490 Page 67 of 501 5/24/05
Confidential / Draft - Do not copy
Parameter Description
0 (&F) Discard "
+CIEV
" and "
^SLCC
" URCs.
1 Discard "
+CIEV
" and "
^SLCC
" URCs when TA-TE link is reserved, e.g. in
online data mode. Otherwise they are forwarded directly to the TE.
2 Buffer "
+CIEV
" and "
^SLCC
" URCs in the TA while TA-TE link is reserved, e.g.
in online data mode, and flush them to the TE afterwards. Otherwise they are
forwarded directly to the TE.
3 Forward "
+CIEV
" and "
^SLCC
" URCs directly to the TE. If TC63 is in online
data mode, URCs are signaled via sending BREAK (100ms) and stored in a
buffer. Once it is back in command mode e.g. after
+++
was entered, all URCs
stored in the buffer will be output.
0 (&F) Keypad event reporting is not supported by TC63.
0 (&F) Display event reporting is not supported by TC63.
0 (&F) Disable indicator event reporting.
2 Enable indicator event reporting.
0 (&F) TA buffer of URCs defined within this command is cleared when 1..3
is entered.
Name of indicator; for a list of all supported indicators please refer to
AT+CIND
and
AT^SIND
.
Value of indicator; for a list of all values for the supported indicators please refer to
AT+CIND
and
AT^SIND
.
Note
• If the ME operates on different instances (MUX channels 1, 2, 3 or ASC0/ASC1) avoid different settings for
routing and indicating SMS. For example, if messages shall be routed directly to one instance of the TE (set
with
AT+CNMI
,
AT^SSDA
), it is not possible to activate the presentation of URCs with
AT+CMER
or
AT+CNMI
on another instance. Any attempt to activate settings that conflict with existing settings on another interface,
will result in CME ERROR, or accordingly CMS ERROR.
(num)
(num)
(num)
(num)
(num)
(str)
(num)