Siemens TC63 - Manual (Page 288)

TC63 AT Command Set
11.10 AT+CGQMIN
s
TC63_ATC_V00.490 Page 288 of 501 5/24/05
Confidential / Draft - Do not copy
11.10 AT+CGQMIN Quality of Service Profile (Minimum acceptable)
Syntax
Command Description
The test command returns values supported as a compound value. If the MT supports several PDP types, the
parameter value ranges for each PDP type are returned on a separate line.
The read command returns the current settings for each defined context.
This command allows the TE to specify a minimum acceptable profile which is checked by the MT against the
negotiated profile returned in the Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local) context identification parameter,
.
A special form of the set command,
AT+CGQMIN
= causes the minimum acceptable profile for context
number to become undefined. In this case no check is made against the negotiated profile.
AT&F
and
ATZ
will undefine the minimum QoS profiles of every context which is not active or not online.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Test Command
AT+CGQMIN=?
Response(s)
+CGQMIN:
, (list of supported s), (list of supported s), (list of
supported s), (list of supported s), (list of supported s)
OK
ERROR
+CME ERROR
Read Command
AT+CGQMIN?
Response(s)
[+CGQMIN: , , , , , ]
[+CGQMIN: ...]
OK
ERROR
+CME ERROR
Write Command
AT+CGQMIN=
[ [, [, [, [, [, ]]]]]]
Response(s)
OK
ERROR
+CME ERROR
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
GSM 07.07 % % % % % % % ! % !
(num)