Siemens TC63 - Manual (Page 394)

TC63 AT Command Set
17.3 AT+CPBR
s
TC63_ATC_V00.490 Page 394 of 501 5/24/05
Confidential / Draft - Do not copy
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with
ATD>
is, depending
on the network, not always possible (refer to GSM 04.08 subclause 10.5.4.7 for details). See also of
AT+CPBW
.
Possible values are:
145
Dialing string includes international access code character '+'
161 National number. Network support of this type is optional.
209 Dialing string has been saved as ASCII string and includes non-
digit characters other than "*", "#" or "+". Note that phonebook entries saved
with this type cannot be dialed.
255 Dialing string is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter .
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.5 , Supported character sets .
Maximum location number for the currently selected storage. For phonebooks located on the SIM this value
depends on the SIM card type.
Maximum length of phone number for "normal" locations. Depending on the storage a limited number of loca-
tions with extended memory is available per phonebook. These locations allow storing numbers with twice the
standard length, which is 2* digits for normal numbers, but only digits for numbers
saved with =209.
Maximum length of assigned to the telephone number. The value indicated by the test command is
given in octets. If is given as GSM characters each character corresponds to one octet. If the
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to GSM 11.11, Annex B [23] . In the worst case the number of UCS2 characters is at
least one less than half the number of GSM characters.
Note
•
AT+CPBR
can be used only after the phonebook data from the SIM have been read successfully for the first
time. Reading starts after successful SIM authentication has been performed, and may take up to 30 seconds
depending on the SIM used. While the initial read process is in progress, an attempt to use any of the phone-
book commands will result in "+CME Error: 14" (SIM busy).
We recommend to take advantage of the "
^SSIM READY
" URC. If enabled with
AT^SSET
, this URC notifies
the user when SIM data are accessible after SIM PIN authentication. The URC will be delivered once the ME
has completed reading data from the SIM card.
(num)
(str)(+CSCS)
(num)
(num)
(num)