Ats7, Tc63 at command set – Siemens TC63 User Manual
Page 156
TC63 AT Command Set
7.14 ATS7
s
TC63_ATC_V00.490
Page 156 of 501
5/24/05
Confidential / Draft - Do not copy
7.14
ATS7 Set number of seconds to wait for connection completion
specifies the number of seconds the TA will wait for the completion of the call setup when answering or
originating a data call. Also referred to as "no answer timeout". To put it plainly, this is the time to wait for the
carrier signal. If no carrier signal is received within the specified time, the TA hangs up.
Syntax
Parameter Description
Number of seconds to wait for connection completion
000...060
(&F)
Notes
• Command
is only applicable to data calls.
• Values greater than 60 (maximum 255) cause no error, but
will be restored to the maximum value of 60.
• The correlation between
and
is important. If the called party has specified a high value for
call setup may fail.
Example: Call setup may fail if ATS7=30 and ATS0=20.
Read Command
ATS7?
Response(s)
OK
Write Command
ATS7=
Response(s)
OK
ERROR
Reference(s)
PIN
ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250
!
%
!
%
%
!
!
!
%
!
(num)(&W)(&V)