Siemens TC63 - Manual (Page 149)

TC63 AT Command Set
7.8 ATDL
s
TC63_ATC_V00.490 Page 149 of 501 5/24/05
Confidential / Draft - Do not copy
7.8 ATDL Redial last number used
Syntax
Command Description
This command redials the last voice and data call number used in the ATD command. If terminated with semi-
colon ";" ATDL dials the last voice call number stored in the "LD" phonebook. Otherwise, the last dialed data or
fax number will be used (not contained in the "LD" phonebook).
Notes
• This command may be aborted generally by receiving a character during execution. Abortion is not possible
during some states of connection setup such as handshaking.
• Parameter "I" and "i" only if no *#-code is within the dial string.
Exec Command
ATDL
[;]
Response(s)
If there is no last number or number is not valid:
+CME ERROR
If no dialtone (parameter ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If connection cannot be set up:
NO CARRIER
If successfully connected and non-voice call (TA switches to online data mode):
CONNECT
When TA returns to command mode after call release:
OK
If successfully connected and voice call:
OK
Reference(s) PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge
4
Last
V.250 % % § % % § § ! ! !