Mapos, Psm9to, Tc63 at command set – Siemens TC63 User Manual
Page 59
TC63 AT Command Set
2.14 AT^SCFG
s
TC63_ATC_V00.490
Page 59 of 501
5/24/05
Confidential / Draft - Do not copy
MEopMode/Airplane: Airplane mode upon ME restart
There are two ways to enter Airplane mode upon restart: One is using
as described
below.
Another approach is configuring the ME to restart into Airplane mode at a scheduled time. In this case, use the
command, set an alarm time and then switch the ME off. When the alarm time is reached the ME
wakes up to Airplane mode, no matter whether
was set "on" or "off".
Parameter
is global for all interfaces, non volatile and will not be reset by
“on“
Causes the ME to enter the Airplane mode each time the ME is restarted or
reset.
After restart or reset, the URC "
" appears and
parameter
is "on". The SIM PIN can be entered using the
command. This enables the ME to read data from the SIM and give access to
SIM PIN dependent AT commands which are available in Airplane mode, such
as phonebook commands or several SMS commands. To notify the user when
SIM data are accessible it is recommended to activate the "
URC and store its presentation mode to the user profile with
To return from Airplane mode to Normal mode set the parameter
to "off"
as described above. If PIN authentication was already done, the ME will try
now to register to the GSM network.
“off“
(P)
Airplane mode will not be activated after ME restart or reset.
Power saving mode 9 timeout
This parameter can be used to query or configure the wake up time for power saving mode 9 (see
with
parameter
=9). The granularity of the timeout value is 100ms (i.e. a value of 10 equal 1 second). The min-
imum timeout value that can be applied is 5, but accuracy is only guaranteed for timeout values greater than 20.
Parameter is global for the ME, volatile and will not be reset by
.
5...20
(P)
...36000
Allowed radio band(s)
The parameters
allow the subscriber to set and query preferences for selecting fre-
quency bands.
ensure that no network activity occurs. The write command cannot be exe-
cuted when making a call, sending or receiving short messages or when the mobile is not registered, but search-
ing for a network. Therefore, to keep track of the module's registration state when changing the band
configuration, it is recommended to activate the URC "
" first (see Section
). For example,
the URC "
: 2" indicates that the ME is in network search mode. In this mode any attempt to change the
band parameters will be rejected with ERROR.
Execution of the write command causes the ME to deregister from and re-register to the network, no matter
setting really changes. In this case too, it is useful to have the URC
"
" enabled.
The status of the SIM PIN authentication remains unchanged, eliminating the need to enter the SIM PIN again
after the change.
The parameter
determines the maximum range of the bands allowed. The value may be one of the single
bands listed below or all valid combinations from the values 1, 2, 4 and 8. Thus, the value range of
"1".."15". To select or deselect a band calculate the sum of the values of all desired bands and enter the resulting
value. For example, for 1800 MHz (2) and 850 MHz (8) please enter the value (10).
Parameter
is global for the ME, non-volatile and will not be reset by
.
“1“
GSM 900 MHz
“2“
GSM 1800 MHz
“4“
GSM 1900 MHz
(str)(+CSCS)
(str)(+CSCS)
(str)(+CSCS)