Interlogix Topaz User Manual - Manual (Page 383)

365
ACCESS ON COMPANY CODE .. CORRECT FACILITY CODE (MANTRAP)
Access was granted based only on the Correct Company Code on the card. Access on
Company code and Mantrap are both set up in Reader Configuration. This card had the
Same Facility encoded on the card as stored in the Site Configuration.
ACCESS ON COMPANY CODE .. WRONG FACILITY CODE
Access was granted based only on the Correct Company Code on the card. Access on
Company code is set up in Reader Configuration. This card had the Wrong Facility
encoded on the card as stored in the Site Configuration.
ACCESS ON COMPANY CODE .. WRONG FACILITY CODE (MANTRAP)
Access was granted based only on the Correct Company Code on the card. Access on
Company code and Mantrap are both set up in Reader Configuration. This card had the
Wrong Facility encoded on the card as stored in the Site Configuration.
AREA SECURE (ALARMS UNMASKED)
Request to Secure (Unmask) the Security Area was granted.
DENIED SECURE (UNMASKING) REQUEST - ACTIVE ALARM
The request to Secured (Unmask) the security area was denied because there is an active
alarm within the security area. The alarm point displays in the event message.
DENIED SECURE (UNMASKING) REQUEST - CONFIGURATION ERROR
The request to Secured (Unmask) the security area was denied because a configuration
error. Example, no alarms in the security area.
DENIED SECURE (UNMASKING) REQUEST - DEVICE ERROR
The request to Secured (Unmask) the security area was denied because a device for the
security area is offline or deactivated.
DENIED SECURE (UNMASKING) REQUEST - UNAUTHORIZED AREA
The request to Secured (Unmask) the security area was denied because the cardholder is
not authorized for Keypad Alarm Masking on this area.
DENIED TWO-MAN ALARM MASKING REQUEST - TIMEOUT
The request to Mask the security area was denied because the security is under control of
Two-Man Masking, and the Host operator must initiate masking on the area.