Interlogix Topaz User Manual - Manual (Page 119)

Chapter 6
Status
101
Alarm Point Status Page
The Alarm Point Status page allows you to check the status of any configured Alarm Point in the
Topaz system. To navigate to the Alarm Point status page click the
button next to Alarm Point
on the main Status page or click the Alarm Point tab button at the top of the window while in any
Status page. The following page displays.
Figure 72.Alarm Point Status page
To check the status of an alarm point, scroll through the list of configured alarm points until the name
of the alarm point you are looking for appears in the list. The color of the text for the alarm point
name shows the status of the alarm point. The color definitions are listed below.
Note: The status of Alarms may also be checked on the Control / Alarm Point page.
If you want to print the contents of the Status window, click Print.
Table 5. Reader status colors
Color Status
Blue Masked
Green Secure
Red Alarm
Peach Open
Peach Short
Peach Ground
Peach Circuit Fault