Interlogix Topaz User Manual - Manual (Page 318)

Topaz
User Manual
300
Masking Alarm Points
To Mask or Unmask the alarm point, right-click the icon and a menu displays next to the icon. From
the menu you can select any of the options that are not grayed out. In the following example the only
options are Mask and Details. If the alarm was currently masked or configured as a non-maskable
alarm point, the Mask option would also be grayed out.
Click the option you want to select it.
Duress Alarm - When a duress PIN code has been entered at the keyboard.
Fire Alarm - Auxiliary output from fire panel has activated.
Forced Open - When a reader door is open without authorization.
Glass Break - Alarm glass break detector has been activated while not masked.
Held Open - When a door is not secured within the allowed time set in the reader configuration.
High Temperature - The temperature in the room has risen above the set threshold.
Low Battery - The DC Battery in the field controller has dropped below the required voltage.
Motion Detector - Alarm motion detector has been activated while not masked.
Request to Exit - A request to exit has been received from the reader door.
Smoke Detector - Auxiliary output from fire panel for a smoke detector has been activated.
Standard Alarm - Other types of alarm points not covered by any other default alarm category
System Input - Low Battery or AC Power Failure.
System Tamper - Field controller panel door has been opened.
Default Alarm Icons (user assignable/configurable)