Interlogix Topaz User Manual - Manual (Page 368)

Topaz
User Manual
350
121 The semaphore time-out period has expired.
122 The data area passed to a system call is too small.
123 File name or volume label contains invalid characters.
125 The disk has no volume label.
126 The specified module could not be found.
127 The specified procedure could not be found.
129 The %1 application cannot be run in Windows 2000 mode.
131 An attempt was made to move the file pointer before the beginning of the file.
132 The file pointer cannot be set on the specified device or file.
139 The system tried to substitute a drive to a directory on a substituted drive.
140 The system tried to join a drive to a directory on a substituted drive.
143 The system cannot join or substitute a drive to or for a directory on the same drive.
137 Not enough resources are available to process this command.
148 The path specified cannot be used at this time.
154 The volume label you entered exceeds the label character limit of the target file system.
155 Cannot create another thread.
161 The specified path is invalid.
162 A signal is already pending.
164 No more threads can be created in the system.
167 Unable to lock a region of a file.
170 The requested resource is in use.
180 The system detected a segment number that was not correct.
183 Cannot create a file when that file already exists.
189 The operating system cannot run %1.
191 Cannot run %1 in Windows 2000 code.
193 Is not a valid application.
196 The operating system cannot run this application program.
197 The operating system is not presently configured to run this application.
206 File name or extension is too long. DOS file names must be 8 characters or less. The file extension must be 3
characters or less.
212 The segment is locked and cannot be reallocated.
214 Too many dynamic-link modules are attached to this program or dynamic-link module.
Error Description