Interlogix Topaz User Manual - Manual (Page 136)

Topaz
User Manual
118
Security Area Setup Report
The Security Area Setup Report recalls how Security Areas have been setup.
To navigate to the Security Area Setup Report page, from any page within the System Setup
pages click the Security Area tab button in the top navigation bar. The following page displays.
Figure 88.System Setup: Security Area
The Security Area page contains the following information:
Security Area Setup The Security Area Setup report recalls how Security Areas have been setup.
All Security Areas?
If Yes is selected, all security areas are listed on the report. If No is selected, then a security area
must be selected from the drop-down list under Security Area Name.
Security Area Name From the drop-down list of pre-configured alarm points, scroll through and select the security area to
be recalled in the report by clicking on the Security Area Name.
Display Report This is the default. Click to display on the Workstation monitor.
Print Report Click to send to the report printer.
Output To File Click to save the report into the file name specified in the Output File Name field. This saves the
report results in a file for later use outside of Topaz.
Output File Name If you selected Output to File, enter the name of the file to contain the report information. The Output
File Name can have up to 64 characters. For example, you can type “Myreport” and the report is
saved into the file named Myreport in the directory where Topaz was installed. You may enter a path
with the file name, for example, “c:\reports\Myreport”. The format of the report files is always plain text
that can be opened in Notepad.
Run Report Click to send the report to the destination specified (display, printer, or file). A message “Report
Completed” displays, with the number of records printed. Click OK to continue.