Figure 227.camera configuration – Interlogix Topaz User Manual User Manual
Page 348

Topaz
User Manual
330
Adding Camera to Map
In the Device tree locate the camera icon. Place the mouse pointer on the
Camera icon, click and
hold down the left mouse button. Drag the icon on the map and release the mouse button.
When you release the mouse button (after dragging the camera icon onto the map), the Camera
Configuration window displays as shown below
Figure 227.Camera Configuration.
Clicking Cancel closes the Camera Configuration window and remove the camera icon from the
map.
Enter the Camera Name of up to 35 alphanumeric characters. The camera name field may only
display a portion of the 35 characters, but the title bar on the camera window (shown below) when
called up displays the full name.
Select the number for the camera that corresponds to its number as configured in the video switcher.
Select the Camera Orientation, which is the direction the camera icon should point in the map by
clicking the up and down arrows to rotate the camera 45 degrees each time.