Interlogix Topaz User Manual - Manual (Page 268)

Topaz
User Manual
250
Relay Page
The Relay page allows you to add a new relay, or modify or delete an existing one.
To navigate the Relay page from any Hardware page, click the Relay tab button navigation bar at the
top of the screen, or from the main Hardware screen click the Relay Output button on the right side
of the screen. The following page displays.
Figure 176.Relay.
The Relay page contains the following information:
Relay Name Enter a name of up to 16 alphanumeric characters for the Relay Name. The name of each
relay must be unique.
Relay Number (Address) Enter the Relay Number (Address) of the relay that is being configured.
Field Panel Select from the drop-down list of pre-configured Field Panels the one to which the relay is
connected.
Alarm Linking Alarm Linking allows you to link the selected Relay to a selected Alarm Point. Any time the
alarm point goes into alarm the relay activates and when the alarm cancels the relay
deactivates. This allows you to link any number of relays to the same alarm point.
Controlled by Alarm Point If the Relay is to be linked to an Alarm Point, select Yes from the list. The default is No.
ALarm Point Name From the drop-down list of configured Alarm Point Names, select the point that activates this
relay when it goes into alarm.
Note: To configure an Alarm Point, click the link arrow to the left and the Alarm Point setup
page opens. Configure the Alarm Point and click Save.