Interlogix Topaz User Manual - Manual (Page 380)

Topaz
User Manual
362
ACCESS DENIED - AREA SECURED, I.E., ALARMS ARE UNMASKED
Access was denied because the Security Area going into is Secured (Alarms are
Unmask). If you do not want this event, enter “No” to “Keypad Masking Allowed” in the
Security Area configuration.
ACCESS DENIED - BAD CARD READ OR FORMAT
Access was denied because the card reader did not get a good card read.
ACCESS DENIED - CARD EXPIRED
Access was denied because the Deactivation Date in the Cardholder's Database has
expired.
ACCESS DENIED - CARD INACTIVE
A cardholder has presented a card requesting access to the area, but access was denied
because the card is inactive.
ACCESS DENIED - CARD NOT ACTIVATED
Access was denied because the Activation Date in the Cardholder's Database is not active
yet.
ACCESS DENIED - CARD NOT DEFINED
Access was denied because this card's encoded number is not defined in the
Cardholder's Data Base. The encoded card number is the number shown is the event
message.
ACCESS DENIED - CARD TERMINATED
A cardholder has presented a card requesting access to the area, but access was denied
because the card has been set to terminated in the cardholder's record.
ACCESS DENIED - DISK ERROR
Access was denied because of a disk error. Call your Distributor or UTC Fire & Security
Representative.
ACCESS DENIED - DURESS
Access was denied because this cardholder is under Duress. Access on Duress is user
configurable under the Site Configuration Menu.