Interlogix Topaz User Manual User Manual
Page 252
Topaz
User Manual
234
Assigning relays to the floors
For each relay that electronically selects a requested floor enter a name for that floor. For information
about wiring the ACU, see the Topaz Hardware Installation Guide. Next to the floor name select the
Security Area that belongs to this floor. A Security Area must be configured for each floor controlled
by the panel. Assign the floor name and Security areas in sequential order.
If there are no Security Areas in the drop-down list, then you must first create your site’s security
areas by going to Setup page, then Security Areas. For more details on how to configure a Security
Area, see
Security Area
Select the pre-configured Security Area from the drop-down list by clicking on the arrow to the right
of the Security Area field and then click the name to select the Security Area for authorization.
If a Security Area is not selected before saving the page, the Floor Name is not saved.
Configured Panels
You can select a field panel by clicking on the name listed.
Description
You can enter or change the description of this field panel.
Save
After you have completed assigning the floors and Security Areas, click Save.
One of the following messages displays:
• If “Operation Complete” is displayed, then no further changes are needed.
• If “Operation Failed” is displayed, then a required field was not entered. Enter the field and try
again.
Clear
At any point if you wish to clear out all entered information, click Clear.
CAUTION: Clicking Clear before clicking Save deletes newly entered data.