Interlogix Topaz User Manual - Manual (Page 382)

Topaz
User Manual
364
ACCESS DENIED - TIME ZONE NOT DEFINED
Access was denied because the time zone is not defined. You may get this event if the
Database has not been fully downloaded to the remote panel.
ACCESS DENIED - USING LOST CARD
Access was denied because the Card Status in the Cardholder Database is set to “Lost”.
ACCESS DENIED - USING STOLEN CARD
Access was denied because the Card Status in the Cardholder Database is set to “Stolen”.
ACCESS DENIED - WRONG AREA
Access was denied because this cardholder requested access into a security area not
assigned to the card.
ACCESS DENIED - WRONG COMPANY CODE
Access was denied because this card's encoded Company Code is not the same as
configured in the Site Configuration.
ACCESS DENIED - WRONG FACILITY CODE
Access was denied because the facility code encoded on the card does not match the
facility code in the Site configuration.
ACCESS DENIED - WRONG KEYPAD NUMBER
Access was denied because this cardholder entered the wrong Keypad Number (PIN) at a
keypad Reader.
ACCESS DENIED - WRONG KEYPAD… TOO MANY ATTEMPTS
This is a special event to notify you this card has exceeded the number of Wrong Keypad
attempts.
ACCESS DENIED - WRONG TIME
Access was denied because this cardholder requested access during the wrong time. The
time (configured in Time Zones) is configured is assigned each security area and there is
also a time zone on each reader.
ACCESS ON COMPANY CODE .. CORRECT FACILITY CODE
Access was granted based only on the Correct Company Code on the card. Access on
Company code is set up in Reader Configuration. This card had the Same Facility
encoded on the card as stored in the Site Configuration.