H3C Technologies H3C Intelligent Management Center - Manual (Page 80)

62
Figure 51 Recommended configuration procedure for LDAP authentication
UAM configuration
To configure RADIUS authentication and LDAP server collaboration:
1. Configure the access device.
2. Configure the access condition.
3. Configure the access policy.
4. Configure a service.
5. Configure the LDAP server.
6. Configure an LDAP synchronization policy.
Configuring the access device
Access device configuration is a prerequisite for configuring the access device group of an access
condition. HP recommends configuring the access device first.
You must add the access device's information (such as the vendor name, IP address, port number, and
key) to UAM, so UAM can exchange RADIUS packets with the access device during authentication.
To enter the access device configuration page, click the User tab and select User Access Policy > Access
Device Management > Access Device from the navigation tree, as shown in Figure 52 . For more
configuration information, see " Configuring access devices ."