H3C Technologies H3C Intelligent Management Center - Manual (Page 48)

30
Figure 17 Recommended configuration procedure for portal authentication and UAM local
authentication
UAM configuration
UAM configuration includes RADIUS authentication configuration and portal authentication
configuration.
Configuring RADIUS authentication
To configure RADIUS authentication:
1. Configure the access device.
2. Configure the access condition.
3. Configure an access policy.
4. Configure a service.
5. Configure an access user.
Configuring the access device
The access device configuration is required for configuring the access device group of an access
condition. HP recommends configuring the access device first.
You must add the access device's information (such as the vendor name, IP address, port number, and
key) to UAM, so UAM can exchange RADIUS packets with the access device during authentication.
To enter the access device configuration page, click the User tab and select User Access Policy > Access
Device Management > Access Device from the navigation tree, as shown in Figure 18 .
For more configuration information, see " Configuring access devices ."