H3C Technologies H3C Intelligent Management Center - Manual (Page 46)

28
To enter the access user configuration page, click the User tab and select Access User > All Access Users
from the navigation tree, as shown in Figure 16 .
For more configuration information, see " Managing ordinary access users ."
Figure 16 Entering the access user configuration page
Access device configuration
For specific commands for each access device configuration item, see the access device configuration
guide or command reference.
To configure the access device:
1. Create a RADIUS scheme.
2. Create a domain.
3. Enable 802.1X and configure the password transport mode.
Creating a RADIUS scheme
An access device exchanges RADIUS packets with UAM according to the configured RADIUS scheme.
When you configure a RADIUS scheme, follow these guidelines:
• You must specify the IP address of the UAM server as the authentication server IP and the
accounting server IP in the RADIUS scheme.
• The shared key and authentication/accounting port specified in the RADIUS scheme must be
consistent with those configured for the access device on UAM.
Creating a domain
When you configure a domain, follow these guidelines:
• For 802.1X authentication, select LAN access as the endpoint authentication function.
• The RADIUS scheme used by the domain must be configured as explained in " Creating a RADIUS
scheme ."
Enabling 802.1X and the password transport mode
Enable 802.1X globally and on interfaces.
• HP Comware switches and H3C switches support the following password transport modes:
{
PAP