H3C Technologies H3C Intelligent Management Center - Manual (Page 372)

354
This setting takes effect only when auto back to primary is enabled. UAM can automatically
switch back to the primary server only if the standby server has been working for a period
equal to or longer than this interval since the primary-to-standby switchover.
6. Click Test to test the connectivity to the LDAP server. If the connection attempt fails, follow the
displayed tips to check for configuration errors.
7. Click OK.
Testing connectivity to an LDAP server
To test the connectivity to an LDAP server:
1. Access the LDAP server list page.
2. Click the Test link for the LDAP server.
The test result appears at the top of the page. If the LDAP server fails to be connected, follow the
displayed tips to check for LDAP server configuration errors.
Modifying LDAP server settings
1. Access the LDAP server list page.
2. Click the Modify icon for the LDAP server you want to modify.
The Modify LDAP Server page appears.
3. Modify basic information:
{
Version—Select the version of the LDAP protocol running on the LDAP server from the list. UAM
supports LDAPv2 and LDAPv3.
{
IP Address—Enter the IP address of the LDAP server. If the LDAP server has more than one NIC,
enter the IP address of the NIC used for communicating with UAM.
{
Port—Enter the TCP port number to which the LDAP server listens for packets sent by UAM. The
default port number is 389, which is used by most LDAP servers.
{
Reconnect Interval—Select the time that UAM must wait before retrying to connect to the LDAP
server after a connection failure, or select Do Not Connect Auto to disable UAM automatically
retrying to connect to the LDAP server after a connection failure.
During this interval, UAM does not try to connect to the LDAP server or accept any
authentication request that must be forwarded to the server. After the interval expires, UAM
retries to connect to the LDAP server.
{
Connection Wait Time—Enter the maximum duration of each connection attempt. If UAM fails to
connect to the LDAP server within this period, the connection attempt is considered failed.
{
Sync Wait Time—Enter the maximum duration of each synchronization. The sync wait timer starts
when UAM starts synchronizing user data from the LDAP server. When this timer expires, UAM
stops the synchronization, regardless of whether the synchronization is complete or not. If you do
not want to set a time limit, set the timer to 0.
{
Use SSL—Select the option to use SSL to encrypt the packets exchanged between UAM and the
LDAP server. When this function is enabled, you must import associated certificates to UAM. For
more information about importing certificates, see " Importing certificates ." This parameter
appears only when IMC is installed on the Windows server.